Becherblindniet AlE-4,8

Nit plin ECORIV® AL/E-4,8


Nit plin cap plat închis pentru coaserea tablelor profilate


Nit ECORIV® AL/E-4,8


Nit cap plat deschis pentru coaserea tablelor profilate


Nit orb ECORIV® K14 AL/E-4,0/4,8


Nit orb cap plat deschis pentru coaserea tablelor profilate


Nit cu eclisă presată ECORIV® ALU-5,2


Nit cu eclisă presată și cap plat deschis pentru coasere table profilate din metal și plastic





The blind rivet is installed by pulling back the mandrel with a special tool, whereupon the mandrel head penetrates into the rivet and expands the protruding material to a closing head.


Installation process blind rivets:

  1. The mandrel of the blind rivet is set into the installation tool and then inserted into the rivet hole. The rivet mandrel is gripped and pulled with the clamping jaws by triggering the installation tool stroke.
  2. The rivet mandrel head thus deforms the shaft end of the rivet body. The process is completed when the mandrel head reaches the height of the component surface.
  3. This position is connected with a strong force increase, at which the rivet mandrel tears off at its predetermined breaking point. The torn mandrel is removed, the residual rivet mandrel remains in the rivet.